Please note: Guide was created on NF4V but will be the same on NF8AC
Step 1: Advanced Setup > Layer2 Interface > ETH Interface
Step 2: Tick and remove all the entries in here and click add then save
Step 3: Advance Setup > WAN Service
Step 4: Remove all the entries then click Add
Step 5: Select ETH then click next
Step 6: Select IP over Ethernet then enter -1 for the Priority and -1 for the VLAN ID then hit next
Step 7: Enable IPV4 then Obtain IP address then click next
Step 8: Select Enable NAT and Enable Firewall:
Step 9: Ensure ETH is listed under 'Selected Default Gateway Interfaces'
Step 10: Select the same for DNS
Step 11: Select apply/save
Comments